11/18/2023 0 Comments Router throttling![]() If the first topology change event occurs after the maximum wait-interval begins, the SPF calculation is again scheduled at the start-interval and subsequent wait-intervals are reset according to the timers throttle spf command. Once the maximum wait-time is reached, the wait-interval remains the same until the topology stabilizes. The wait-interval doubles when at least one topology change event is received during the previous wait-interval. The wait-interval indicates the amount of time to wait before scheduling an SPF calculation in an event of topology change in this case, 1000 milliseconds. Spf-max-wait: Maximum wait between two SPF calculations. Spf-hold: Minimum hold-time between two SPF calculations. ![]() Spf-start: Initial delay to schedule an SPF calculation after a topology change. The OSPF SPF Throttling is configured using the command timers throttle spf OSPF router configuration command. By default, SPF interval is chosen dynamically and depends on frequency of topology changes. SPF runs when there is a topology change. It ignores the new speed settings in the cable modem and I cannot seem to reset it.OSPF Shortest Path First Throttling feature allows to schedule SPF calculations in milliseconds interval and delay SPF calculations during network instability. It almost seems like pfSense remembers the original speed settings when I first set it up and now that they've changed. The speed is still throttled to the 140/10. ![]() I've tried resetting and changing the "Speed and Duplex" settings on both the WAN and LAN, but this does not change anything. With pfSense in place, I'm throttled to 140mb/10mb. That said, my speeds have never changed even running a speed test directly on the router using speedtest-cli.Īs noted, if I remove the router and go straight from the PC to the cable modem, I get the speeds provided / advertised by Xfinity. They have since upgraded me several times and most recently to the 600mb down and 20mb up. When I first moved into my house, that was my Internet speeds provided by Xfinity, my speed was 150mb down and 10mb up. When I connect the router, it is throttled to 140mb down and 10mb up. If I remove the router and connect it directly to a PC, I get 600mb down and approximately 24mb up. I have pfSense running on a Protectli Vault 6 Port, Firewall Micro Appliance/Mini PC and I'm running the latest stable release (2.6.0-RELEASE (amd64))Īnyway, for whatever reason, my pfsense router is throttling my Internet connection.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |